User's Manual
Table Of Contents
- Chapter 1
- General Information
- Helpful Website
- Where to Get Technical Support
- How this Manual is Organized
- Optional Software
- Conventions Used in this Manual
- Precautions
- Chapter 2
- Seeker Introduction
- What is the Seeker?
- Seeker Features
- Easy Frequency Configuration
- Multiple Frequency Presets
- Channel Tag Compatibility
- GT Noise Discrimination
- Squelch Operation
- Source Localization
- Vehicle Battery Protection
- Equipment Supplied with Your Seeker
- Accessories & Replacement Parts for Your Seeker
- A Guided Tour of Your Seeker
- Front View
- Back View
- Right Side View
- Bottom View
- Display Screen
- A Guided Tour of Your Mobile Mount
- Front View
- Left Side View
- Rear View
- About Your Seeker’s Battery
- Overview
- If Your Seeker Does Not Turn On
- Checking the Battery Level
- Charging the Battery
- Updating Your Seeker’s Firmware
- Chapter 3
- Seeker Operation
- Configure Settings
- Seeker’s Operation Modes
- Measurement Mode
- PC Communications Mode
- Display Modes
- Signal Level
- Battery Charge Level
- Peak Hold
- Preset Frequencies
- Channel Tag
- Snapshot Modes
- Pre-Fix
- Post-Fix
- No Snapshot
- Chapter 4
- Leakage Testing
- Before You Begin Leakage Testing
- Testing For Leaks
- Chapter 5
- Seeker MCA III Introduction
- What is Seeker GPS?
- Equipment Supplied with Your Seeker MCA III
- Accessories for Your Seeker MCA III
- Device Overview
- Front View
- Left Side View
- Rear View
- Display Screen Overview
- Chapter 6
- Seeker MCA III Operation
- Configure Settings
- Seeker GPS Display Modes
- Mobile Mount Communication Successful
- GPS Signal
- Data Synchronization
- Chapter 7
- Data Upload Options
- Standard Internet Connection
- Wi-Fi
- Fleet Management System Integration
- Chapter 8
- Appendix
- General Specifications
- Display Messages & Error Codes
- Seeker Error Codes
- MCA III Error Codes
- Access Point Error Codes
- Seeker & MCA II Communication Messages
- Seeker & MCA II Memory Full Messages
- Trilithic Broadband Instruments 2-Year Limited Warranty
44
Seeker & Seeker MCA III Operation Manual
Display Screen Overview
The display screen of the MCA III is used to display the setup and operation status of the
unit.
Normal Display Screens
The information displayed on this screen is for reference only, the settings shown here
can be adjusted using the Seeker Setup software.
The Seeker MCA III Home Screen shows the name and version number of the installed
rmware/software.
Activity / Error Screens
If a new activity and/or error occurs within the device, the system displays a popup
message to indicate the type of activity and then returns to the previous screen after 10
seconds. If a new activity or error occurs prior to expiration of the 10 seconds, then the
new message will be displayed and the 10 seconds will start again. The only exceptions
to this rule are the Wi-Fi, Cellular, and Ethernet Upload In Progress screens which will
remain on the screen until the upload is complete, an error occurs, or the Select button
is single clicked.
Using the Select Button
To navigate the display screens, perform the following actions using the Select button
on the back of the MCA III:
Single click the Select button to scroll through the device status menus,
indicated by blue lines and the symbol shown to the left or dismiss any
popup messages related to device activity and/or errors.
DoubleclicktheSelectbuttontoenteraspecicstatusmenu,
indicated by red lines and the symbol shown to the left.