User's Manual
Table Of Contents
- Chapter 1
- General Information
- Helpful Website
- Where to Get Technical Support
- How this Manual is Organized
- Optional Software
- Conventions Used in this Manual
- Precautions
- Chapter 2
- Seeker Introduction
- What is the Seeker?
- Seeker Features
- Easy Frequency Configuration
- Multiple Frequency Presets
- Channel Tag Compatibility
- GT Noise Discrimination
- Squelch Operation
- Source Localization
- Vehicle Battery Protection
- Equipment Supplied with Your Seeker
- Accessories & Replacement Parts for Your Seeker
- A Guided Tour of Your Seeker
- Front View
- Back View
- Right Side View
- Bottom View
- Display Screen
- A Guided Tour of Your Mobile Mount
- Front View
- Left Side View
- Rear View
- About Your Seeker’s Battery
- Overview
- If Your Seeker Does Not Turn On
- Checking the Battery Level
- Charging the Battery
- Updating Your Seeker’s Firmware
- Chapter 3
- Seeker Operation
- Configure Settings
- Seeker’s Operation Modes
- Measurement Mode
- PC Communications Mode
- Display Modes
- Signal Level
- Battery Charge Level
- Peak Hold
- Preset Frequencies
- Channel Tag
- Snapshot Modes
- Pre-Fix
- Post-Fix
- No Snapshot
- Chapter 4
- Leakage Testing
- Before You Begin Leakage Testing
- Testing For Leaks
- Chapter 5
- Seeker MCA III Introduction
- What is Seeker GPS?
- Equipment Supplied with Your Seeker MCA III
- Accessories for Your Seeker MCA III
- Device Overview
- Front View
- Left Side View
- Rear View
- Display Screen Overview
- Chapter 6
- Seeker MCA III Operation
- Configure Settings
- Seeker GPS Display Modes
- Mobile Mount Communication Successful
- GPS Signal
- Data Synchronization
- Chapter 7
- Data Upload Options
- Standard Internet Connection
- Wi-Fi
- Fleet Management System Integration
- Chapter 8
- Appendix
- General Specifications
- Display Messages & Error Codes
- Seeker Error Codes
- MCA III Error Codes
- Access Point Error Codes
- Seeker & MCA II Communication Messages
- Seeker & MCA II Memory Full Messages
- Trilithic Broadband Instruments 2-Year Limited Warranty
38
Seeker & Seeker MCA III Operation Manual
Pre-Fix
Torecordthepre-xleakageinformationrecordedbytheSeeker,
press the Snapshot button when the following screen is displayed:
Post-Fix
Torecordthepost-xleakageinformationrecordedbytheSeeker,
press the Snapshot button when the following screen is displayed:
No Snapshot
To cancel the snapshot of the information recorded by the Seeker,
press the Snapshot button when the following screen is displayed:
In Snapshot Mode, the display will cycle through the screens
displayed above until the user makes a selection. This
enables the user many opportunities to take a snapshot of the
leakage signal.