User's Manual
Table Of Contents
- Chapter 1
- General Information
- Helpful Website
- Where to Get Technical Support
- How this Manual is Organized
- Optional Software
- Conventions Used in this Manual
- Precautions
- Chapter 2
- Seeker Introduction
- What is the Seeker?
- Seeker Features
- Easy Frequency Configuration
- Multiple Frequency Presets
- Channel Tag Compatibility
- GT Noise Discrimination
- Squelch Operation
- Source Localization
- Vehicle Battery Protection
- Equipment Supplied with Your Seeker
- Accessories & Replacement Parts for Your Seeker
- A Guided Tour of Your Seeker
- Front View
- Back View
- Right Side View
- Bottom View
- Display Screen
- A Guided Tour of Your Mobile Mount
- Front View
- Left Side View
- Rear View
- About Your Seeker’s Battery
- Overview
- If Your Seeker Does Not Turn On
- Checking the Battery Level
- Charging the Battery
- Updating Your Seeker’s Firmware
- Chapter 3
- Seeker Operation
- Configure Settings
- Seeker’s Operation Modes
- Measurement Mode
- PC Communications Mode
- Display Modes
- Signal Level
- Battery Charge Level
- Peak Hold
- Preset Frequencies
- Channel Tag
- Snapshot Modes
- Pre-Fix
- Post-Fix
- No Snapshot
- Chapter 4
- Leakage Testing
- Before You Begin Leakage Testing
- Testing For Leaks
- Chapter 5
- Seeker MCA III Introduction
- What is Seeker GPS?
- Equipment Supplied with Your Seeker MCA III
- Accessories for Your Seeker MCA III
- Device Overview
- Front View
- Left Side View
- Rear View
- Display Screen Overview
- Chapter 6
- Seeker MCA III Operation
- Configure Settings
- Seeker GPS Display Modes
- Mobile Mount Communication Successful
- GPS Signal
- Data Synchronization
- Chapter 7
- Data Upload Options
- Standard Internet Connection
- Wi-Fi
- Fleet Management System Integration
- Chapter 8
- Appendix
- General Specifications
- Display Messages & Error Codes
- Seeker Error Codes
- MCA III Error Codes
- Access Point Error Codes
- Seeker & MCA II Communication Messages
- Seeker & MCA II Memory Full Messages
- Trilithic Broadband Instruments 2-Year Limited Warranty
28
Seeker & Seeker MCA III Operation Manual
Mobile Mount Charging
Placing the Seeker into the Mobile Mount will begin Mobile Mount charging.
• The Mobile Mount DC power cable must be connected to the Mobile Mount and
the vehicle power supply before Mobile Mount charging can begin.
• When the Seeker is off and it is charging, the device will go into a background
charging and nothing will be shown on the display screen.
• When the Seeker is on and is charging, the display will remain on the
Measurement mode screen. From the Measurement mode screen, press the
Select button once to view the on screen bar graph showing the battery charge
level. Press the Select button a second time and the charge icon will blink while
the bar graph shows charging progress.
• If the Seeker is not completely seated in the Mobile Mount, the charge screen
may not be displayed. If the Charge icon blinks but the bar graph isn’t shown,
then the Seeker is not detecting any power to the Mobile Mount. If two or more
bars are displayed, then power is present and charging is in progress.
• Measurement mode IS NOT disabled while the Seeker is mobile mount charging.
Updating Your Seeker’s Firmware
ToupdateyourSeeker’srmware,youmustusetheSeekerSetupsoftware.Formore
informationonhowtoupdateyourrmware,seetheSeekerSetupSoftwareOperation
Manual.