User's Manual
Table Of Contents
- Chapter 1
- General Information
- Helpful Website
- Where to Get Technical Support
- How this Manual is Organized
- Optional Software
- Conventions Used in this Manual
- Precautions
- Chapter 2
- Seeker Introduction
- What is the Seeker?
- Seeker Features
- Easy Frequency Configuration
- Multiple Frequency Presets
- Channel Tag Compatibility
- GT Noise Discrimination
- Squelch Operation
- Source Localization
- Vehicle Battery Protection
- Equipment Supplied with Your Seeker
- Accessories & Replacement Parts for Your Seeker
- A Guided Tour of Your Seeker
- Front View
- Back View
- Right Side View
- Bottom View
- Display Screen
- A Guided Tour of Your Mobile Mount
- Front View
- Left Side View
- Rear View
- About Your Seeker’s Battery
- Overview
- If Your Seeker Does Not Turn On
- Checking the Battery Level
- Charging the Battery
- Updating Your Seeker’s Firmware
- Chapter 3
- Seeker Operation
- Configure Settings
- Seeker’s Operation Modes
- Measurement Mode
- PC Communications Mode
- Display Modes
- Signal Level
- Battery Charge Level
- Peak Hold
- Preset Frequencies
- Channel Tag
- Snapshot Modes
- Pre-Fix
- Post-Fix
- No Snapshot
- Chapter 4
- Leakage Testing
- Before You Begin Leakage Testing
- Testing For Leaks
- Chapter 5
- Seeker MCA III Introduction
- What is Seeker GPS?
- Equipment Supplied with Your Seeker MCA III
- Accessories for Your Seeker MCA III
- Device Overview
- Front View
- Left Side View
- Rear View
- Display Screen Overview
- Chapter 6
- Seeker MCA III Operation
- Configure Settings
- Seeker GPS Display Modes
- Mobile Mount Communication Successful
- GPS Signal
- Data Synchronization
- Chapter 7
- Data Upload Options
- Standard Internet Connection
- Wi-Fi
- Fleet Management System Integration
- Chapter 8
- Appendix
- General Specifications
- Display Messages & Error Codes
- Seeker Error Codes
- MCA III Error Codes
- Access Point Error Codes
- Seeker & MCA II Communication Messages
- Seeker & MCA II Memory Full Messages
- Trilithic Broadband Instruments 2-Year Limited Warranty
25
Seeker & Seeker MCA III Operation Manual
Left Side View
Mountingarm
The arm is used to secure the Mobile Mount
to the vehicle. Use the knob to tighten and
loosen the arm and then adjust the angle
of the arm to achieve the proper mounting
angle. The arm should be securely
fastened to the vehicle with four screws or
bolts.
Rear View
Audiooutputconnection
This connection is used to connect the
audio from the Seeker to an external audio
system.
MCAIIIserialconnection
This connection is used with the Mobile
Communications Adapter serial cable to
connect the Seeker Mobile Mount to the
Seeker MCA III.
Antennainput
This connection is used to connect an external monopole antenna. The rubber duck
antenna does not function when the Seeker is placed in the Mobile Mount.
DCpowercableconnection
• Red wire - Connect to an always-on positive (+) 12 Volt power supply between
the vehicle battery and the vehicle key switch
• White wire - Connect to an ignition-switched positive (+) 12 Volt power supply
• Both black wires - Connect to ground or the negative (-) battery terminal