User's Manual
Table Of Contents
- Chapter 1
- General Information
- Helpful Website
- Where to Get Technical Support
- How this Manual is Organized
- Optional Software
- Conventions Used in this Manual
- Precautions
- Chapter 2
- Seeker Introduction
- What is the Seeker?
- Seeker Features
- Easy Frequency Configuration
- Multiple Frequency Presets
- Channel Tag Compatibility
- GT Noise Discrimination
- Squelch Operation
- Source Localization
- Vehicle Battery Protection
- Equipment Supplied with Your Seeker
- Accessories & Replacement Parts for Your Seeker
- A Guided Tour of Your Seeker
- Front View
- Back View
- Right Side View
- Bottom View
- Display Screen
- A Guided Tour of Your Mobile Mount
- Front View
- Left Side View
- Rear View
- About Your Seeker’s Battery
- Overview
- If Your Seeker Does Not Turn On
- Checking the Battery Level
- Charging the Battery
- Updating Your Seeker’s Firmware
- Chapter 3
- Seeker Operation
- Configure Settings
- Seeker’s Operation Modes
- Measurement Mode
- PC Communications Mode
- Display Modes
- Signal Level
- Battery Charge Level
- Peak Hold
- Preset Frequencies
- Channel Tag
- Snapshot Modes
- Pre-Fix
- Post-Fix
- No Snapshot
- Chapter 4
- Leakage Testing
- Before You Begin Leakage Testing
- Testing For Leaks
- Chapter 5
- Seeker MCA III Introduction
- What is Seeker GPS?
- Equipment Supplied with Your Seeker MCA III
- Accessories for Your Seeker MCA III
- Device Overview
- Front View
- Left Side View
- Rear View
- Display Screen Overview
- Chapter 6
- Seeker MCA III Operation
- Configure Settings
- Seeker GPS Display Modes
- Mobile Mount Communication Successful
- GPS Signal
- Data Synchronization
- Chapter 7
- Data Upload Options
- Standard Internet Connection
- Wi-Fi
- Fleet Management System Integration
- Chapter 8
- Appendix
- General Specifications
- Display Messages & Error Codes
- Seeker Error Codes
- MCA III Error Codes
- Access Point Error Codes
- Seeker & MCA II Communication Messages
- Seeker & MCA II Memory Full Messages
- Trilithic Broadband Instruments 2-Year Limited Warranty
2
Seeker & Seeker MCA III Operation Manual
FCC Part 15 Compliance
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
Pursuant to FCC 15.21 of the FCC rules, changes not expressly approved by Trilithic, Inc.
might cause harmful interference and void the FCC authorization to operate this product.
The antennas used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the device and receiver
• Connect the device into an output on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help
The Seeker MCA III can only be used with the following Trilithic approved Wi-Fi antennas:
• P/N 2071677001 - 2.4 GHz antenna
• P/N 2071677004 - 2.4 & 5 Ghz antenna