User Manual

EASy-PLUS
®
User Manual
18 –
TRILITHIC
Rev 1.02
SELECTING CONTACT-CLOSURES
EVENTS Contact Closures
Typical headend components which need a contact-closure to operate are a comb generator or Motorola’s OM-
1000 data modulator.
During the enabling and configuration of each event, there will normally be a contact-closure paired with the
event. The relay contacts are found at the rear of the EASy-PLUS
®
system.
Enable the necessary number of contact-closures at the rear terminal strip of the EASy-PLUS
®
unit by clicking
on the Enable buttons. There are four (4) available.
SELECTING TTL OUTPUTS
EVENTS TTL Outputs
Make sure to enable each of the TTL Outputs you intend to use for each event selected. The timing for each
individual TTL output will be set using the I/O CFG tab.
Enabling TOO many outputs is not a problem. Just make sure the outputs you ARE using are enabled.