User's Manual

DRAFT
EASyCAP Encoder/Decoder - Manual
21
Select the Edit button to change the network settings, and then adjust the following settings:
LAN Port 1 (eth0)
The following settings can be adjusted for LAN Port 1 (eth0)
 DHCP - Select this checkbox to enable DHCP to automatically assign the IP
Address, Subnet, and Gateway of the Encoder/Decoder. When this check box is
selected these fields will be grayed out and cannot be manually adjusted.
 IP Address - When DHCP is not enabled, enter the IP Address of the Encoder/
Decoder into this field.
 Subnet - When DHCP is disabled, enter the Subnet Mask of the Encoder/Decoder
into this field.
 Gateway - When DHCP is disabled, enter the Gateway of the Encoder/Decoder
into this field.
LAN Port 2 (eth1)
The following settings can be adjusted for LAN Port 2 (eth1)
 Disabled - Select this checkbox to disable this port when only using one Ethernet
connection. When this check box is selected these fields will be set to 0.0.0.0, be
grayed out, and cannot be manually adjusted.
 DHCP - Select this checkbox to enable DHCP to automatically assign the IP
Address, Subnet, and Gateway of the Encoder/Decoder. When this check box is
selected these fields will be grayed out and cannot be manually adjusted.
 IP Address - When DHCP is not enabled, enter the IP Address of the Encoder/
Decoder into this field.
 Subnet - When DHCP is not enabled, enter the Subnet Mask of the Encoder/
Decoder into this field.
 Gateway - When DHCP is not enabled, enter the Gateway of the Encoder/Decoder
into this field.
Attempting to assign both network interfaces to DHCP may
cause unreliable communication.