User's Manual

DRAFT
EASyCAP Encoder/Decoder - Manual
20
Network Settings
Network Interfaces
To setup the network interfaces of the Encoder/Decoder, select the plus (+) sign to the left of
Network, and then select the Interfaces link. The Interfaces setup page will be displayed as
shown below.
Network Connection - The EASyCAP Encoder/Decoder must be on a network where CAP
feeds are available and it must also have network connectivity to the EASy Series Encoder/
Decoder. Two different network configurations are possible as follows:
 Single Network Connection - If both the EASyCAP Encoder/Decoder and EASy
Series Encoder/Decoder are on the same network (or subnet) only the Ethernet
connection eth0 should be configured. In this configuration select the Disabled check
box for the second Ethernet port eth1, otherwise communications will be unreliable.
 Dual Network Connection - If the EASyCAP Encoder/Decoder and EASy Series
Encoder/Decoder are on two different networks (or subnets) both Ethernet connections
eth0 and eth1 must be configured. In this configuration each Ethernet port is assigned
to a different network (or subnet).