Quick Start Guide

1 0 18

Adjustment Procedures

LOCKING EXTERNAL ADJUSTERS

(

1-8x28

)

Zero the riﬂe as described previously and lock the adjusters by pushing

down. Once locked, remove the adjuster body by turning the threaded

top cap counter-clockwise (1). Once removed, lift the adjuster body and

rotate to zero (2). Press the adjuster body back down and reinstall the

threaded cap (3).

ADJUSTABLE BRIGHTNESS

The Brightness Adjustment Dial is located on the left side of the housing and

is equipped with an “OFF” setting between each of the brightness settings.

This enables the user to be able to easily switch the unit on or off and return

to the last brightness setting. The brightness adjustment for the optic has ten

settings, (1) being the dimmest and (10) the brightest. If a dual color offering,

there will be ten settings, ﬁve of each color, with (1) being the dimmest

and (5) brightest for each color. Turn the Brightness Adjustment Dial to the

preferred brightness setting based on conditions.

DIOPTER ADJUSTER (EASY FOCUS EYEPIECE)

The Diopter Adjuster (B) allows the user to quickly match the user’s

prescription. Adjustments are made by simply turning the Diopter Adjuster

in the direction which brings the reticle into focus. An indicator (+ / -) is a

useful reference point for returning the focus to your customized position.

EXTERNAL ADJUSTERS / RETURN TO ZERO

Once the riﬂe’s elevation is zeroed, remove the adjuster turret by turning the

threaded top cap counter-clockwise (1). Remove the top cap (2), remove the

adjuster body (turret) (3), then loosen the three hex screws around the Return to

Zero disk with the provided 1.5mm hex wrench.

After loosening the hex screws, let

the Return to Zero disc drop to the adjuster housing (4) and rotate clockwise (5) until

the Return to Zero disk stops. Once the Return to Zero is set to the desired position,

tighten the three hex screws to 5 in. oz. or ﬁnger tight using the 1.5mm hex wrench

(6).

To complete the Return to Zero adjustment, reinstall the adjuster body at the

zero position (7), and reinstall the top cap (8).

1 2

7 8