User's Manual

Faults
The Transponder will not continue to operate when a fault condition is present
and one of the following messages appears on the display.
Message
Action to resolve
FPGA Fault
Call Service center
ROM checksum failed XXXX
Call Service center
Receiver fault or no signal
Call Service center
Transmitter failed
Call Service center
Squitter failure
Call Service center
Data Timer
Call Service center
EEROM Read Data
Call Service center
FlightID []
Call Service center
StrToNum
Call Service center
Too many tasks
Call Service center
Task bit
Call Service center
Timer Pool
Call Service center
No runnable tasks
Call Service center
I2C Write Data
Call Service center
QPut claimed message
Call Service center
Destroy pooled message
Call Service center
Free non-pooled message
Call Service center
Comm write before open
Call Service center
Two clients on one Comm port
Call Service center
ttywrch called
Call Service center
__rt_raise called
Call Service center
__raise called
Call Service center
_sys_exit called
Call Service center