GAS COOKTOP MANUAL JZS75012 JZS75013 JZS75012N1 JZS95001
FIRE OR EXPLOSION HAZARD If the information in these instructions is not followed exactly,a fire or explosion may result causing property damage,personal injury or death. Read these instructions completely and carefully. When installing a gas appliance the use of old flexible connectors can cause gas leaks and personal injury.Always use a new flexible connector. MATERIALS YOU MAY NEED ■Gas line shut-off valve ■Pipe joint sealant, resists action of natural and propane gases.
CONVERTING TO PROPANE GAS(OR CONVERTING BACK TO NATURAL GAS FROM PROPANE) This cooktop leaves the factory set for use with natural gas. The conversion orifices and instructions can be found attached to the regulator.Keep these instructions and all orifices in case you want to convert back and natural gas. Take off the burner cap and the aluminum cap, then use suitable instrument for replacing the nozzle “J”. Installing the cooktop all the models) A.
Electric Connections Shock Hazard:This appliance must be properly grounded.Failure to do so can result in electric shock. Electrical Requirements--110-120volt,60Hz,properly grounded circuit protected by a 15-amp or 20-amp circuit breaker or time delay fuse.It is recommended that a separate circuit serving only this cooktop be provided. NOTE:Use of automatic, wireless, or wired external switches that shut off power to the appliance are not recommended for this product.
Adapting To Different Types of Gas Matters Needing Attention Before carrying out any maintenance work,disconnect the appliance from the gas and electric supply. To change the nozzles of burners use the following procedure: Lift up the burners and unscrew the nozzles using an adjustable spanner of 7mm and change the nozzles(Picture “J”) with those designed for the new gas supply according to the information shown below.
K. Cleaning of the enameled parts:to maintain the features of the enameled parts they must be cleaned frequently with soapy water.Never use the abrasive powders.Avoid leaving acid or alkaline substances on the enameled parts(vinegar,lemon juice,salt,tomato juice etc.) and washing the enameled parts when they are still warm. L. Cleaning of the stainless steel parts:clean the parts with soapy water and then dry them with a soft cloth.
