GAS COOKTOP MANUAL JZS32003N1 JZS32003N2
FIRE OR EXPLOSION HAZARD If the information in these instructions is not followed exactly,a fire or explosion may result causing property damage,personal injury or death. Read these instructions completely and carefully. When installing a gas appliance the use of old flexible connectors can cause gas leaks and personal injury.Always use a new flexible connector. MATERIALS YOU MAY NEED ■Gas line shut-off valve ■Pipe joint sealant, resists action of natural and propane gases.
Installing the cooktop The silver galvanized brackets to the bottom of the cooktop(on all the models) A. Locate electric outlet and gas shut-off valve beneath cabinet. B. Insert the cooktop centered into the cutout opening. Make sure the front edge of the countertop is parallel to the cooktop.nd C. Make final check that all required clearance are met. D. Once the unit is in place screw the cooktop into the cabinet using brackets (not included) to secure the unit into place.
Electric Connections Shock Hazard:This appliance must be properly grounded.Failure to do so can result in electric shock. Electrical Requirements--110-120volt,60Hz,properly grounded circuit protected by a 15-amp or 20-amp circuit breaker or time delay fuse.It is recommended that a separate circuit serving only this cooktop be provided. NOTE:Use of automatic, wireless, or wired external switches that shut off power to the appliance are not recommended for this product.
Adapting To Different Types of Gas Matters Needing Attention Before carrying out any maintenance work,disconnect the appliance from the gas and electric supply. To change the nozzles of burners use the following procedure: Lift up the burners and unscrew the nozzles using an adjustable spanner of 7mm and change the nozzles(Picture “J”) with those designed for the new gas supply according to the information shown below.
K. Cleaning of the enameled parts:to maintain the features of the enameled parts they must be cleaned frequently with soapy water.Never use the abrasive powders.Avoid leaving acid or alkaline substances on the enameled parts(vinegar,lemon juice,salt,tomato juice etc.) and washing the enameled parts when they are still warm. L. Cleaning of the stainless steel parts:clean the parts with soapy water and then dry them with a soft cloth.
