Use and Care Manual

If pairing is successful, the LED will blink twice. Then, the Bluetooth indicator appears on the

Thermostat display.

If pairing is unsuccessful or time-out after 8 minutes, the LED will stop blinking and the Sensor will go

into standby mode. In Standby mode, the connection between the sensor and the thermostat is not set

up. All the sensor circuits will be shut down to save power. Hold the Pairing Button for 2 seconds to

initiate the Pairing mode again.

Note: If the sensor is previously registered, it will be added to the thermostat network

automatically in Pairing mode. If disconnected, the sensor will change to Pairing mode

automatically and try to reconnect with the thermostat. User can also press the pairing button

to restart the sensor in Pairing mode.

Fig 9-A