Use and Care Manual

8
6
Fig 8-A
5. Press Next once your sensor LED is blinking to complete the pairing process. This will initiate a scan
function and the Thermostat will scan for sensors in range. Sensors that are detected will be listed by
their MAC addresses. Users can select from the list if there is more than one sensor to be paired and
add the sensors. Note: It may take up to 30 seconds to detect and pair a new sensor.
6. Once your sensor is successfully added, the Connection Status, Temperature, and Occupancy State
will be “Not Used”. Wait for 1-2 minutes then Sensor Data will be auto-updated or you may click on the
"Refresh Sensor Data" button to update the sensor readings.