Use and Care Manual

If the LED does not blink after the Sensor is powered up or after battery insertion or the Sensor exits

Pairing mode after eight minutes, hold the Pairing Button for 2 seconds to re-initiate pairing to the

thermostat. The sensor will enter Pairing mode again and broadcast itself for 8 minutes for thermostat

scanning. LED will blink briefly in the mode.

Step 2: Add Occupancy Sensor to the system

at: portal.tricklestar.com You can also use the QR

code here.

On the Dashboard screen, select Devices, then click on your

Thermostat Name to enter the Thermostat page.

Select Sensors on the left panel, then click on “+” to add a new sensor.

4. Enter the name for your sensor.

5. Press Next once your sensor LED is blinking to complete the pairing process. This will initiate a

scan function and Thermostat will scan for sensors in range. Sensors that are detected will be

listed by their MAC addresses. User can select from the list if there is more than one sensor to be

paired and add the sensors. Note: It may take up to 30 seconds to detect and pair a new sensor.

6. Once your sensor is successfully added, the Connection Status, Temperature and Occupancy

State will be “Not Used”. Wait for 1-2 minutes then click on the "Refresh Sensor Data" button to

update the sensor readings.

Fig 7-A