Use and Care Manual

6
Pairing the sensor
Step 1: Remove Battery Insulator
To
power up the sensor, gently remove the sensor back cover to detach the cover from the clips. You
will
see
an insulator on the battery “REMOVE BEFORE USE”. Lift the battery by pulling on the
battery
insulator and gently peel off the battery insulator.
Insert the battery back into the sensor’s battery compartment. Reassemble the sensor back cover.
When the Sensor is powered up, it enters Pairing mode automatically. The LED starts blinking and
continues blinking up to eight minutes.
REMOVE
BEFORE USE
Battery
Insulator
Insert the
battery
Fig 6-A
Fig 6-B