Use and Care Manual

13
Occupancy Detection
The occupancy sensor is equipped with an occupancy detection function. It uses PIR sensor to detect
the infrared signal of moving bodies. You can also enable or disable the occupancy detection function
for each sensor individually through the Portal.
You can adjust the Absence Detection Sensitivity and Occupancy Detection Sensitivity, and enable or
disable the Occupancy Detection feature of the thermostat. If disabled, regardless of any sensor output
and individual sensor settings, the thermostat will ignore the occupancy status received and will not
automatically change the Mode. However, it will not shut off the sensor detection circuit and you can
still check the occupancy states for each sensor through the Portal or App.
The occupancy detection feature is enabled if
:
a)
The Occupancy Detection Enabled is set to Yes at the Portal.
b)
The Sensor Enabled of each individual sensor is set to Yes at the Portal.
c)
The Sensor Status in the Portal is Connected.
d)
The active Mode is Home or Away (not Sleep).
e)
The Thermostat is on Schedule mode, not on Temporary/Permanent/Vacation Hold or when user
has changed the Mode manually.