Installation Guide

If the LED does not blink after the Sensor is powered up or after battery

insertion or the Sensor exits Pairing mode after eight minutes, hold the Pairing

Button for 2 seconds to re-initiate pairing to the thermostat. The sensor will

enter Pairing mode again and broadcast itself for 8 minutes for thermostat

scanning. LED will blink briefly in the mode.

Step 2: Add Occupancy Sensor to the system

1. Log in to your TrickleStar Portal account

at: portal.tricklestar.com You can also use the QR

code here.

2. At Dashboard screen, select Devices, then click on your Thermostat Name

to enter Thermostat page.

3. Select Sensors on the left panel, then click on “+” to add a new sensor.

4. Enter the name for your sensor.

5. Press Next once your sensor LED is blinking to complete the pairing process.

This will initiate a scan function and Thermostat will scan for sensors in range.

Sensors that are detected will be listed by their MAC addresses. User can

select from the list if there is more than one sensor to be paired and add the

sensors. Note: It may take up to 30 seconds to detect and pair a new sensor.

Once your sensor is successfully added, the Connection Status, Temperature

and Occupancy State will be “Not Used”. Wait for 1-2 minutes then click on

the "Refresh Sensor Data" button to update the sensor readings.