Installation Guide

12
Ready for use
Normal mode
The Occupancy Sensor is now ready for use. In Normal mode, the connection
between the sensor and the thermostat is set up. The sensor will automatically
update the Connection Status, Room Temperature, Occupancy State and
Sensor Battery Level in the Tricklestar Portal and Tricklestar App.
You can enable or disable the sensor detection LED operation in Normal mode
through the TrickleStar Portal Sensor settings (Occupancy Detection LED). This
option also disables the sensor detection LED by default, meaning the sensor
LED will not blink when it detects a movement. If the LED is enabled, it will blink
once when there is a confirmed movement detection in every 30 seconds
interval.