Installation Guide

www.tricklestar.com

AV Advanced Powerstrip+

IR & Motion Multi-Sensor

The multi-sensor is connected to the powerstrip via the RJ11 port marked

“sensor.” Mount the multi-sensor on the underside of the TV near the IR

receiver on the TV (typically located next to the TV's power on/off button).

The multi-sensor must be located within line of sight of where you

normally use your remote controls.

Power Connection

The Product must only be plugged into a grounded receptacle for surge

protection to operate correctly. All connected devices should be plugged

directly into the Product. Use of an extension cord, adaptor or other

powerstrip in conjunction with the Product will void all warranties.

Sensor/RJ11 Port

Plug the IR & motion multi-sensor into this port.

There will be a soft audible ‘click’ when the connector is inserted correctly.

Surge LED

When illuminated, it indicates that the surge protection is functioning

normally. If this LED illuminates red or extinguishes at any time, the

Product was sacrificed to protect your devices and must be replaced.

Ground LED

When illuminated, it indicates that the Product is correctly grounded.

If not illuminated, there is a grounding problem and you must contact an

electrician to properly ground the socket. Surge protection will not work

with an improperly grounded outlet.

Switched LED

When illuminated, it indicates that the switched outlets are receiving power.

Resettable Circuit Breaker

All outlets on the Product are protected. If the surge, ground, and

switched LEDs are not illuminated and/or connected devices are not

receiving power, press the circuit breaker to activate power.

Always-on Outlets

Equipment that requires continuous power should be plugged into the

always-on outlets.

< tv > Outlet

The outlet marked < tv > is the control outlet and includes true RMS

power measurement.

IMPORTANT: THE TV MUST BE PLUGGED INTO THIS OUTLET

Switched Outlets

If there is no IR or motion detected, these outlets will switch off.

TAV-Link Cable (optional, not supplied)

If there is no IR or motion detected, TAV-Link will send high-level CEC

commands to certain HDMI connected devices, allowing them to safely

store their data and settings prior to powering down

4 5

Product Overview