IMPORTANT INFORMATION YOU MUST READ THE WHOLE OF THIS INSTRUCTION BOOK BEFORE YOU USE THE APPLIANCE. FOLLOW THE ADVICE CAREFULLY. KEEP THE BOOK FOR FUTURE REFERENCE. IF YOU SELL OR GIVE AWAY THE APPLIANCE, MAKE SURE THAT THE BOOK IS PASSED TO THE NEW OWNER. WARNINGS & The following warnings are provided in the interest of overall safety. You must read them before the appliance Is installed or used. INSTALLATION This appliance should not be installed in a bathroom or shower roam.
Installation You should position your dryer near a window so that warm damp air can escape We suggest you use a separate venting hose 10 avoid condensation. (A venting hose should be available from your dealer). (A permanent connection may be made with the optional Wall/Window Vent Kit}. Make sure that the air inlets at the back are not blocked and do not allow fluff to accumulate around your dryer. Place the filter in its operating position as shown in diagram below.
2.1 22 23 Electrical information WARNING: THIS APPLIANCE MUST BE EARTHED. ‘The mains lead of this appliance is fitted with a BS 1363A 13 amp fudged plug. To change fuse tintype of plug use an A.S.T.A. approved fuse to BS 1362 type. 1. Remove the fuse cover {A) and fuse (B) 2. Fit replacement 13A fuss into fuse cover 3. Refitboth.into plug IMPORTANT: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted.
3 Control panel Heat switch Timer knob The timer. Select the drying time from the recommendations shown on the control panel, Turn the timer knob clockwise until the setting required appears at the top. The heat switch. Select full or half heat as recommended on the control panel. Operation All dripping wet articles in a towel to remove excess water, Sort out the clothes into groups of similar fabrics and colors. Check the care label inside the garment.
4.5 4.6 When drying sarge items such as sheets; we suggest you stop the dryer to redistribute the load. To stop the machine during the middies of the programmer simply open the door; the drum will stop rotating automatically and restart when you close the door. To lengthen or shorten the programmer, fum the timer knob. After engraving the dried clothes clean the filler as follows: PUY the filter upwards. — Remove any thread or fluff by hand of with a soft brush.
Any problems? if the clothes are not dry alter normal drying time: — Check that the filter is clean. Check that you used the correct heater chatting, Check that the venting hose is not blocked (sometimes a strong wind may cause a back pressure). — Check that you have not sel the timer within a cool down period. — Check that the heater cut-out has not operated. N Simply press the red button at the back of your M= dryer. it it has operated then a sharp “click” [ E will be heard.
