IMPORTANT INFORMATION YOU MUST HEAD THE WHOLE OF THIS INSTRUCTION BOOK BEFORE YOU USE THE APPLIANCE. FOLLOW THE ADVICE CAREFULLY. KEEP THE BOOK FOR FUTURE REFERENCE. IF YOU SELL OR GIVE AWAY THE APPLIANCE, MAKE SURE THAT THE BOOK IS PASSED TO THE NEW OWNER. WARNINGS ® The following warnings are provided in the interest of overall safety. You must read them before the appliance is installed or used. INSTALLATION = This appliance should not be installed in a bathroom or shower om.
Installation You should position your dryer nears window southeastward dare air car escape. We suggest you use a separate venting hose to avoid condensation. (A venting hose should be available from your dealer). (A permanent connection may be made with the optional Wall/Window Vent Kit}. Make sure that the air inlets at the back are not blocked and do not allow fluff to ‘accumulate around your dryer. Place the filter in its operating position as shown in diagram below.
2.1 22 23 Electrical information WARNING: THIS APPLIANCE MUST BE EARTHED. The mains lead of this appliance is fitted with a BS 1363A 13 amp fused plug. To change fuse in this type of plug use an A.8.T.A. approved fuse to BS 1362 type. 1. Remove the fuse cover (A} and fuse (B) 2. Fit replacement 13A fuse anti fuse cover 3. Refit both into plug IMPORTANT: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fetid.
Timer knob The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the [lefter “E” or by the Earth symbol < or colored green or green and yellow. The BLUE wire must be connected to the terminal marked with the letter "N” or colored black. The BROWN wire must be connected to the terminal which is marked with the teeter “L” or colored red. Control panel Heat switch The timer.
44 4.5 4.6 Select correct heat position {see programmer chart on fascia panel). Set the timer 1o the correct position {see programmer chart on fascia panel}. The drum will now begin to rotate and stop when the timer automatically reaches the ‘O’ position. Should the clothes become dry before the cycle has finished the sensor dry thermostat will automatically switch off the heater and prevent over drying and save energy although the drum will stile rotate.
Don’ts Do not — Overload the dryer. Do not— Dry articles singly as they tend to role up and so increase drying time. Do not — Dry swollen or woe mixture articles unless the article is fa belled as suitable. Do not — Allow venting hose (where applicable) or filter to become blocked. Do not — Allow fluff to accumulate around the tumble dryer. Do not— Attempt to dry dripping wet articles, or items containing foam rubber, or rubber-fiche materials in the dryer. .
