User manual

28
THE BATTERY
1. The battery is located on the left hand side of the
front plinth.
2. To gain assess to the battery, open the main
oven door and lift up the battery holder lid.
3. Fit the new battery ensuring (+) terminal is next
to the (+) sign on the battery. See Fig. 4.
4. Close the lid of the battery holder.
PRESSURE TESTING
1. The oven injector is used as a pressure test
point.
Remove the oven furniture. Remove oven
burner box retaining clips (one spring clip from
each side) and remove box front cover. Replace
one clip back into the right hand side of the
burner box. Remove oven burner by removing
the spring clip from the right hand side of the
oven burner and slide burner off injector, whilst
easing it forward and taking care not to strain the
F.S.D. phial.
2. Connect the pressure gauge to the oven injector.
3. Check the supply pressure by turning the
thermostat on and one hotplate tap full on and
light the appropriate burner. The pressure
should be either:-
(i) For Natural Gas 20mbar
(ii) For LP. Gas. The pressure must be set
to 28 mbar for use on butane or 37 mbar
for use on propane.
4. Turn off the taps, disconnect the pressure gauge
and replace oven burner and cover, ensuring
that the F.S.D phial is correctly located into the
bracket on the burner.
5. Check operation of the oven.
CHECKING THE GRILL
Place the grill pan containing the grid, with the
handle attached, into the grill compartment. Light the
grill burner by turning the grill tap full on and
pressing the ignition button on the fascia panel. As
soon as the burner is lit the button can be released.
CHECKING THE HOTPLATE
Lift the lid. Fit the burner crowns and caps ensuring
that they are correctly seated. Fit the pan supports.
Check each of the hotplate burners in turn by turning
the hotplate tap to its full on position and pressing
the ignition button. As soon as the burners are lit the
button can be released.
Fig.4.