WARNINGS AND GUIDANCE it is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get know the functions of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
CONTENTS Specification Installation Fitting the Hob The Wiring Diagram Electrical Connections Use of the Hob Maintenance and cleaning Help us to help you Servicing Guarantee For Twelve Months Page Page Page Page Page Page Page Page Page Page Warning The installation of the hob and connection to the electricity supply must be done by qualified installers according to standards and regulations currently in force, SPECIFICATIONS One Rapid Sealed Plate: One Rapid Sealed Plate: One Normal Sealed Plate: One Norma
INSTALLATION This Trinity Bendix hob is designed to be The minimum distance combustible material can installed into any work surface 600mm or more be fitted directly above the hob is 700mm, see deep. Fig. 4 The dimensions and positioning of the cut out are detailed in Fig. 2. FO 120 Fig. 2 FO 0311 Fig.4 If the hob is installed adjacent to either a rear or side walkies, a minimum gap of 55mm must be left between the edge of the hob and the wall(s).
FITTING THE HOB FITTING THE HOB TO THE WORKTOP Before fitting the hob into the cut out an adhesive seal must be fitted to the underside outside edge (Fig. 5}, of the hob. it is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below. a) Sealing gasket FOO Fig.5 The body of the hob is 30mm thick for fitting into 30mim thick work surfaces.
ELECTRICAL CONNECTIONS WARNING: THIS APPLIANCE MUST BE EARTHED. ‘The manufacturer declines to accept any liability should this safety measure not be observed. The hob Is designed to be connected to 240V 50Hz electricity supply. Al electrical installation work should be carried out by & competent person and should conform to all current rules and regulations.
USE OF THE HOB The control pane! located to the right hand side of the hob has a visual representation of four plates by each of the four control knobs {o indicate which plate the knob controls. To activate any of the plates turn the appropriate control knob anti-clockwise from the zero position to the desired heat setting. To switch off, turn the control knob clockwise to the zero position.
Saucepans Saucepans for use on solid plates should have several characteristics: They should be fairly heavy duty. They should fit the heat area exactly, or be slightly larger for efficient use, NEVER smaller. They should have a flat base to ensure good contact with the plate (Fig. 11). This is particularly important when using pans for high temperature frying or pressure cooking. Ensure pans are large enough io avoid liquids being split onto the plates.
MAINTENANCE AND CLEANING Before any maintenance or cleaning is carried out, you must ISOLATE the appliance from the electricity supply. To ensure the best results from your hob and to prolong its good look, regular cleaning and maintenance is essential. Cleaning The Sealed Plate Hob The enameled parts of the hob should be cleaned with a soft cloth soaked in warm detergent water, for more stubborn marks, a light scouring cream may be used.
GUARANTEE FOR 12 MONTHS TRINITY BENDIX STANDARD GUARANTEE CONDITIONS This guarantee is in addition fo your statutory and other legal rights.
