User manual

6
INSTALLATION ABOVE CUPBOARD OR DRAWER
If the hob is to be installed above a cupboard or
drawer it will be necessary to fit a heat resistant
board below the base of the hob on the underside of
the work surface.
It is also recommended to carry out the electrical
connection to the hob as shown in the 2 illustrations
a) Sealing gasketFITTING THE HOB TO THE WORKTOP
Before fitting the hob into the cut out, an adhesive
seal must be fitted to the underside outside edge
(Fig. 4) of the hob. It is essential that no gaps are left
in this seal in order to prevent spillage near the hob
seeping into the cabinet below.
ON/OFF SWITCH
FLEX
OUTLET
ON/OFF SWITCH
FLEX
OUTLET
FO 0763
FO 0764
FO 0402
A
Fig. 4