WARNINGS AND GUIDANCE 1t is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get know the functions of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
CONTENTS Specifications Installation Fitting the Hob The Wiring Diagram Electrical Connections Use of the Hob Maintenance and Cleaning Help us to help you Servicing Guarantee For Twelve Months WARNING The installation of the hob and connection to the electricity supply must be done by qualified installers according to standards and regulations currently in force.
INSTALLATION This Trinity Bendix hob is designed 1o be installed into The minimum distance combustible material can be any work surface 800mm or more deep. fitted directly above the hob is 700 mm, ses Fig. 4 The dimensions and positioning of the cut out are detailed in Fig, 2. Cut out of size Back wall S FO 0958 700 anm FO 129 Fig. 4 Fig. 2 If several functions are to be combined (2-burner gas hob + 2 hot plate electric hob etc.
FITTING THE HOB FITTING THE HOB TO THE WORKTOP 1} Place the putty on the worktop around the edge of the cut out. 2y Put the hob into position and tighten the fixing brackets. 3) Trim any excess putty from the perimeter of the hob, a) Sealing gasket FO0199 Fig. § The body of the hob is 30 mm thick for fitting into 30mm thick work surfaces. If your work surface is less than 30mm thick a batten should be fitted around the underside perimeter edge of the cut cut to 30mm overall thickness.
ELECTRICAL CONNECTIONS All electrical connections must be carried out by competent persons in accordance with the current regulations, This appliance is designed to be connected to a 240V 50Hz AC electrical supply. The appliance is fitted with a 3 core flexible supply cord incorporating a molded amp plug top fitted with a amp PASTA rated fuse. THIS APPLIANCE MUST BE EARTHED. ‘The manufacturer will not accept liability should this safety measure not be observed.
USE OF THE HOB Hob Top Normal sealed plate 1500W/180 mm dia. Normal sealed plate 1000W/145 mm dia. Clairol panel Control knob for back sealed plate Control knob for front sealed plate Light to indicate functioning of sealed plates Sealed Hotplates The control panel incorporates knobs to operate the two heating elements, Normal Plate This Is a position control knob: 0 = Off and 1-6 indicates the levels of power up fo the maximum, o, 4 Very gentle To keep food warm. To mek butter and chocolate.
Saucepans Saucepans for use on solid plates should have several characteristics: They should be fairly heavy duty. They should fit the heat area exactly, or be slightly {age for efficient use, NEVER smaller, They should have a flat base to ensure good contact with the plate (Fig. 10). This is particularly important when using pans for high temperature frying or pressure cooking. Ensure pans are large enough to avoid liquids being split onto the plates.
MAINTENANCE AND CLEANING Before any maintenance or cleaning is carried out, you must ISOLATE the appliance from the electricity supply. To ensure the best results from your hob and to prolong its good look, regular cleaning and maintenance is essential. Cleaning the Sealed Plate Hob The enameled parts of the hob should be cleaned with a soft cloth soaked in warm detergent water, for more stubborn marks, a light scouring cream may be used.
GUARANTEE FOR 12 MONTHS TRINITY BENDIX STANDARD GUARANTEE CONDITIONS This guarantee is in addition to your statutory and other legal rights.
