User manual

RATING PLATE
Record the model and serial numbers on page 23 of
this book from the rating plate. This is situated on the
lower front frame of the cooker and can be seen
upon opening the main oven door.
The cooker must be protected by a suitably rated
fuse or circuit breaker. The rating of the cooker is
given on the rating plate.
INSTALLATION
WARNING: THIS COOKER MUST BE
EARTHED.
If your cooker has been damaged in transit, contact
your supplier immediately. DO NOT attempt to install
it.
Your cooker left the factory fully packaged to protect
it from damage. If it is delivered without packaging
and damage has occurred, the manufacturer cannot
accept responsibility. Contact your Electricity
Company for advice.
Once the packaging has been removed the cooker
should only be moved by hand. DO NOT use a sack
barrow or any other aid to lift the cooker as damage
may occur.
For your own safety, we recommend that your
cooker is installed by a competent electrician. The
installation must comply with current I.E.E.
Regulations.
The cooker must be connected to the correct
electrical supply as stated on the voltage label on the
cooker, through a suitable cooker control unit
incorporating a double pole switch having a contact
separation of at least 3mm in all poles.
The cable connecting the electricity supply to this
cooker must have conductors of sufficiently high
cross-sectional area to prevent overheating and
degradation. Six square millimetres ( 6.0mm
2
) is the
minimum recommended cross-sectional area.
The cooker must be protected by a suitably rated
fuse or circuit breaker. The rating of the cooker is
given on the rating plate.
The cable should be routed away from potentially hot
areas marked by X in the diagram below.
To move the cooker, open the oven door, and lift the
cooker by holding inside the top of the compartment.
This is a type Y cooker which means it is
free-standing and can be fitted with cabinets on one
or both sides. It may also be fitted in a corner setting.
Ensure that the cooker is standing level.
Side walls which are above hob level should be
protected by heat resistant non-combustible material
and MUST NOT be nearer than 40mm to the hob
side.
A nominal air gap of 2mm all around the cooker is
required to enable the cooker to be moved into
position.
A spacer has been incorporated into the back of the
appliance to ensure an air gap of 10mm is
maintained at hotplate level. Tiles or other forms of
deep wall covering should not obscure this gap.
7
INTRODUCTION
This cooker complies with Radio Interference
requirements of EEC Directive 87/308/EEC.
REAR VIEW