User Manual

6
OPERATING INSTRUCTIONS
The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.
The appliance can be installed to recirculate or extract contaminated air.
Control Panel
The hood can be switched on pushing directly onto the requested speed without fi rstly having
to select 0/1 button.
L T1 T2 T3 T4 T5 F
Touch
Basic functions
Indicator lights
Dual Function
L
When briefl y pressed it switches the lighting system on/off.
Touch control unlit Lights off
When pressed for 2 seconds it starts the lighting system
in “courtesy light" mode.The lamps are fed at a reduced
power of approximately 5W. Such function can be stopp-
ed by pressing the touch control for 2 seconds or just by
pressing it shortly in order to return to the normal lighting
mode. In courtesy light mode the touch control is not lit.
Touch control lit Lights on
Touch control unlit Courtesy light on
T1
When pressed the motor is stopped, regardless of the
speed it is set to.
Touch control lit Motor on
Touch control unlit Motor off
T2
When pressed the motor is set to the fi rst speed
Touch control lit
T3
By a brief pressing the motor is set to the second speed.
Touch control lit Second speed on
By pressing the touch control for approximately 2 seconds the
Delay function is enabled, i.e delayed shutdown of the appli-
ance ensuring a complete elimination of the residual odours.
This function can be activated at OFF- position and at 1°, 2°
and 3°speeds. It can be stopped in advance by pressing any
of the touch controls (T) with the exception of T3. The Delay
function works according to the following scheme:
1°speed / OFF = 20 minuets
2°speed =15 minutes
3°speed = 5 minutes
Flashing touch control Delay function on
T4
When pressed the motor is set to the third speed
Touch control lit
T5
When pressed the motor is set to the intensive speed
timed to 5 minutes. At the end of 5 minutes of intensive
speed the hood starts again at the speed it was set to
previously. In case the hood is set to the intensive speed
directly from OFF-state it will then start from the fi rst
speed after 5 minutes of intensive speed.
Touch control lit
F
When pressed for 4 seconds it resets the fi lter alarm s-
ignal indicated by fl ashing of the touch control T1.This
procedure can be carried out only when the motor is
stopped.
Touch control lit Metal grease fi lters saturation
alarm.Metal grease fi lters need
to be washed.The alarm starts
up after 100 working hours.
Flashing touch control Charcoal odour fi lter saturaion
alarm.Charcoal fi lter has to
be replaced and metal grease
fi lters washed.The alarm
starts up after 200 working
hours.(Activation; check the
paragraph "Odour fi lter")