SITE REQUIREMENTS A dry, level, and a relatively smooth floor, with the services brought to the appliance. A minimum clearance is required each side of the appliance. UNPACKING & INSTALLATION Remove the box, corer Pisces and paler Remove back panel screws and lift panel clear. Remove the inner transit fixings that secure the straps 1o the tub. Slacken the outer screws and swing the fop transit swaps up and the lower straps down to lay in the corners of the cabinet.
ELECTRICITY Mains lead: care 27m 9t Fused and earthed supply: 220V50Hza.c. Fuse ratings: 134 CONNECTING THE ELECTRICITY WARNING THIS APPLIANCE MUST BE EARTHED 1 this appliance is fitted with 3 non-rewire able plug for which your socket is unsuitable the plug should be cut off and an appropriate fug lifted. The removed plug shouts be disposed of as insertion of the pig Into 8 13 amp socket is Kelly 10 cause an electrical hazard.
Instantaneous Water Heaters This mode is suitable for use with same makes of instantaneous gas water-heaters. Full details compatible water-heaters should be obtained from the heater manufacturer or Gas supplier. The use of these heaters may require more frequent cleaning of the Auto washer water inject filters than would be necessary with other water heating methods.
OPERATING INSTRUCTIONS Know your {BENDIX Autoworker electronic Mains Oneself Switch Controls power to the machine. Mains On Light Glows t indicate the machine is energized. Half load Suits For smaller wash loads. Once set it limits the quantity of water 1o the making. Temperature Selector Control Moves freely and gives a range of wash temperatures from 30°C 80°C. Use the wash programmer goods on the machine fascia or refer to the programmer chart on pages 8 & 9 forth correct temperature.
Using your auto washer electronic Always use a low sussing detergent in your machine, £.g. Persia Automatic, as these are specially formulated to work in conjunction with your Auto washer electronic machine o give the best results, Detergents will be flushed automatically into the machine from the detergent dispenser. The suds lever should never rise more than straightway up the porthole.
Loading the Drum When you have a full wash load of shirts, towels, pillowcases, pajamas and similar items, pack them loosely into the drum. Large aims, a candlewick bedspread for stance, should be washed individually, When washing a mixed load, put medium and small sized items into the dim alternately. A shes should be picked up by the center tent wise, shaken and then forded, pressing out the air, ‘Wash Temperature Select the correct temperature according o programmer designed.
BEFORE USING CHECK THAT 1. Achievement is plugged in and switched on. 2. Thessaloniki fully open " 3. Prostheses not kinked. 4. The laundry is loafed into the machine and the door is closed firmly. 5. The appropriate amount of detergent and fabric softener has been added to the detergent dispenser. 6. The ‘half toad’ control has been pressed where appropriate. v 7. Thecorrectternperature has been selected. 8.
What's gone wrong? If your making won't work, check the following list and make sure that you haven't overlooked anything. it will certainly help you and us also. 1. Check’that the machine is plugged in and switched on. 2. Check the fuse, you could try another appliance from the same outlet incarnate main fuse has blown. 3. Bethesda stopcocks has been turned on fully, 4. Have you selected the Programmer? 5.
