BEND ) reamer o Auto washer de lux Model 7001 ERRATA Pages& 9 Programmer 7 uses cold fill only, For this programmer (Maj detergent should( o Wash). per-wash compartment (A soap dispenser, () of the You are now the proud owner of a Bendix Auto washer de lux, you will be pleased to find that it washes, rinses and spins without you having to handle the clothes in between times, You will obviously want to obtain the best possible wash.
SITE REQUIREMENTS A dry, level, and a relatively smooth floor, with the services brought 1o the appliance. A minimum clearance is required each side of the appliance UNPACKING & INSTALLATION Remove the box, corner pieces and pallet, Remove back panel scows and lift anal clear. Remove the inner transit fixings that secure the brackets to the tub. Shaken the outer screws and swing the top transit brackets up and the lower brackets dawn to lay ins the corners of the cabinet.
PRy Ma instead: core 27m Oft Fused and earthed supply: 240V 50Hz a.c. Fuse ratings: 134 TONTO NG HIE ELECTRICITY Before switching on make sure that the voltage of your electricity supply is the same as that indicated on the rating plate.
Ostentatious Water Heaters This model is suitable for use with some makes of instantaneous gas water-jesters. Full details of compatible water-heaters should be obtained loom the heater manufacturer or Gas showroom. The use of these heaters may require more frequent cleaning of the Autoworker water infer filters ‘than would be necessary with other water heating methods.
Mains Quaff Nation Controls power to the machine. Mains On Light Glows to indicate the machine is energized. Haft Load Burton For smaller wash loads, Once set it limits the quantity of water tithe machine. Temperature Defector Control Gives & range of wash temperatures from 30°C 96°C. Use the wash programmer guide on the machine fascia 1o refer to the programmer chart on pages B & 9. This will provide correct temperature required.
Using your BENDIX auto washer de lux Always use a low sussing detergent in your making, eg. Rel Automatic, Persia Automatic, s these are specially formulated to work in conjunction with your Auto washer de machinate to give the best resits. Detergents will be flushed automatically into the machine from the detergent dispenser, The suds level should peer rise more than hatchway up the porthole.
Coffee, Tea, Fruit, Wine, Grass, Ink, Ballpoint Tav Scotch Iron Mound Grease, Fat, Lipstick Blood, Egg, Milk Cream.Meat Juice Mildew Stains These are usually removed in the wash. For old stains, snakeskin biological wash product, then launder in the usual way. Dab with mentholated spirits over softcover pad, then launder in the usual way. Do not use Mentholated spirits on Trice. Treat INK stains on Trice with Glycerin. Serape off excess, dab with petrol, over softhearted pad. {Caution.
Loading the Bran When you have a full wash load of shirts, towels, pillowcases, pajamas and similar items, pack them loosely into the drum. Large items, a candlewick bedspread for When washing a mixed load, put medium and small sized items into the drum alternately. A sheet should be picked up by the center tent wise, shaken and then folded, pressing out the air Wash Temperature Select the correct temperature according to programmer required.
BEFORE USING CHECK THAT 1. The machine is plugged in and switched on, Both HOT and COLD stopcocks are fully open {unless a cold water adulator has been fitted. Bendix Part No. 25115). The hoses are not kinked. 4. The laundry is loaded into the machine and the door is closed firmly. B. The appropriate amount of detergent and fabric softener has been added to the detergent dispenser, 6. The ‘half load’ bunion has been pressed where appropriate. 7. Thecorrecttemperature has been selected, 8.
What's gone wrong? If your machine won't work, check the following list and make sure that you haven‘toverlocked anything. twill certainly help you and us also. 1. Hatcheck machine is plugged in and switched on. 2. Check the fuse. You could try another appliance from the same outlet encase the main fuse has blown., 3. Be'sure the stopcocks have bean turned Fully on. 4. Have you selected the Programmer? 8, Look to see if the door is fully closed.
