Instructions / Assembly

Pre-measure foam piece.

Then cut and form to Round

or Square shape depending

on type of A/C Condenser

or Heat Pump

Install collar onto top of A/C Condenser or Heat Pump by:

1) removing PSA tape on foam air collar

2) applying taped side to clean dry surface of equipment

**Make sure foam air collar creates a seal between the

underside of the top cover of TRiCC utility cover and the top of

the A/C Condenser or Heat Pump unit so that air flowing from

fan is directed up and out of louvered top.

If more than 1 foam piece is required to obtain seal between

A/C Condenser or Heat Pump, extra kits are available from

dealer.

** IMPORTANT INSTRUCTIONS **

TRiCC

utility cover Air Collar Installation

Air Collar Kit Part No. 8426 1 piece foam, 2” x 2” x 108”

www.triccover.com - Help line 224-MYTRiCC

Document 9030 created 3/2/20102

For proper efficiency and operation, this Kit must be installed on all A/C Condensers and Heat Pumps.