Use and Care Manual

Table Of Contents
Read each step carefully before starting. It is very important that each step of instruction is
performed in the correct order. If these steps are not followed in sequence, assembly
difficulties will occur.
Installation of Cams and Pins
Screw the pin into the hole. To set the cams correctly, ensure that the arrow on the cam is opening
to the hole of the pin it is locking. Lock the cam by turning the cam head with a screwdriver until it
is tightened. Please do not use an electric screwdriver to assemble the unit.
P-05
A
A
A
www.tribesigns.com
Pin
No gap
Valve on/off (lower pressure on)
Install side panel
Install draw side
A
B
C
Valve
Valve
A
B
C
Three section guide rail diagram
Take section C out of the guide rail (note that section AB is a whole, do not pull section
B ard,otherwise the guide rail will be damaged)
C