Operation Manual

4. S-Video Output

Analog video output for connecting Home Theatre systems through matching input jacks.

5. Analog Video Output

Analog video output for connecting Home Theater systems or monitors. The available video output

signal format is "CVBS"

6. Digital Audio Output (Coaxial)

Dolby Digital and Linear PCM Stereo output for digital input of a HiFi or A/V system with integrated

digital decoder.

7. Analog Audio Output (Stereo)

Audio Stereo L/ R signal for connecting your TV, HiFi or Home Theatre system.

8. SCART Connector (TV)

For connection of all audio and video signals of this digital receiver to the TV set.The video signal

is output as RGB or "CVBS" (F-BAS) respectively.

9. SCART Connector (VCR)

For connection of all audio and video signals of this digital receiver to a video cassette recorder

(VCR).The video signal is output as "CVBS" (F-BAS) respectively

10. VHF / UHF Terrestrial Antenna Input

Connect your antenna to this input jack (RF IN). For so-called "active" antenna systems a suitable

power supply can be provided from through jack (to be selected in the "General Settings" menu,

item "Antenna Booster Power").

11. Antenna Loop-Through Output

If you have another analogue or digital receiver and you wish to use the same antenna, then you

can connect it to this "antenna loop-through" output jack (RF OUT)

12. Mechanical Power Switch

Please note that the STB will be isolated completely from the 230V mains supply only after setting

this mechanical power switch to OFF.

CAUTION:

Do not mix up RF IN and RF OUT jacks when connecting your antenna system.

DVB T1