Operation Manual

Move to the bottom of the screen where the satellite TP information is displayed and then
press the OK button.
Enter the TP information you want to add, such as Frequency, Polarization (H / V), Symbol
Rate, etc. (Use the Numeric buttons to enter Frequency and Symbol Rate information, and
use the buttons to enter H / V information).
Press the OK button to register the TP information.
To cancel the TP information addition process, press the BACK button.
Enter the TP information, such as Frequency, Polarization (H / V), Symbol Rate, etc., and then
press the OK button. (Use the Numeric buttons to enter Frequency and Symbol Rate
information, and use the buttons to enter H / V information).
To cancel the entries you have made, press the BACK button or the EXIT button.
Delete a Satellite
Use this to delete the selected satellite. However, you won't be able to delete any of the
satellites, which were set as factory defaults.
Use the CH UP and CH DOWN buttons to select the satellite you want to delete.
Press the button. A message appears, asking for your confirmation.
If you want to delete, press the OK button.
Otherwise, press the "Back" button or the EXIT button.
Modify Satellite TP Information
To modify the TP information, move to the satellite you want and then press the OK button.
The satellite TP information appears on the right side of the screen.
Select the TP information you want to modify and then press the OK button.
Modify the TP information, such as Frequency, Polarization, Symbol Rate, etc., and then
press the OK button. (Use the Numeric buttons to enter Frequency and Symbol Rate
information, and use the buttons to enter H / V information).
After the changes are made, press the OK button to update the TP information.
To cancel the TP information modification process, press the BACK button.
Add Satellite TP Information
GB
9.8 Transponder Editor
The "Transponder Editor" allows you to change, add, and
delete satellite information.
Add a Satellite
Use the buttons to move to the last field on the list.
Press the OK button. The screen will change to allow you to
enter the name of the satellite you are adding.
Use the buttons to enter letters. Use the buttons to
change the cursor position.
When you have finished entering the satellite name, press
OK.
Press the OK button to enter the added satellite's TP
information of the added satellite.
When the TP information input field appears in the right
panel, press the OK button.
Go to the "Main Menu", select "Channel Manager", select
"Transponder Editor", and then press the OK button.
Note on Network Search:
In this search mode, the receiver first collects the network information first from the TP you
selected. Then a Manual Search takes place to research all the channels in that network. The
number of searched channels may vary, depending on the TPs present in that network. Select
whether to use the network information of the TP stream specified in "Select Transponder". I.e,
download the TP information of the satellite you want to find from a particular TP and then use this
to Manual Search the channels in the TP group. The number of channels searched may vary
depending on the TP information transmitted. Select Network Search and then use the buttons
to set it.