Operation Manual

- Press EXIT for loading the pre-programmed channel data. That may take some 30 seconds.
(Please wait.)
or
- Press MENU for selecting the "General Settings" menu. Then select " 3. Channel Manager"
and perform item "1. Auto Search" or item "2. Manual Search", according to your needs.
5. Getting Started
This chapter explains some settings you will need to make before using the receiver for the first time.
For easier operation the most popular TV and radio channels of ASTRA, HotBird and TURKSAT
satellite have been factory-preset.
You may change the pre-programmed channel list or its sorting at any time.
5.1 Connecting the Satellite Receiver
Mains Supply
This unit is designed for any common mains voltage (95 to 250 volts~, no adjustment needed).
TV Set
Connect the TV SCART connector on this satellite receiver to the SCART connector of your TV set,
using a commonly available 21-pole SCART cable.
Antenna
Connect the coaxial cable from your satellite antenna system (LNB) to the IF INPUT connector of
the satellite receiver.
For details, please refer to section "4.3 Rear Panel Connections".
Press the POWER
(12)
button on the rear panel to switch on the
unit. With the button on the remote control you can toggle
between "Operation" and "Standby" mode. In the operating
mode the 8-charater (VFD) front panel display shows the Ch.
name and number of the actual TV or radio program. In the
"Standby" mode the actual clock time will appear in the
display, provided it has been set correctly or has been
synchronized by a transmitter signal before. When the
POWER
(12)
button is OFF the front panel display does not
show. During initial setup the language selection menu
appears on your TV.
Use the buttons on the remote control or on the receiver to
select the language of your choice and then press the OK
button. When selecting ENGLISH, a WELCOME screen
appears on your TV screen:
Your Digital Satellite Receiver is factory pre-programmed.
After you have adjusted several settings in the GENERAL
SETTINGS menu you have to press [EXIT] for loading the
pre-programmed channel data.
If you don't want to use this data press [MENU] and select
Channel Manager to start your own searching.
Press OK to enter the "General Settings" menu.
In the "General Settings" menu you can perform individual settings that are related to the local time
zone (summertime included), your TV set, and desired language selections. For adjustments,
please use the and buttons and see the explanations at the bottom of the menu screens.
GB
5.2 First Steps