Operation Manual

DVB 168 S (GB)-17 050908

www.triax.com

Notes:

Satellite Positions are stored in the "Antenna Positioner". Therefore, you will need to manually

set the position of satellites that the "Antenna Positioner" does not currently support.

9.5 USALS

This convenient function locates the desired satellite by USALS if latitude/longitude of the

receiving place and satellite longitude are known.

Move to USALS mode by using the buttons at the DiSEqC item in the "General Settings"

menu.

Move to "Auto Search" or "Manual Search" to search the desired channel in USALS mode.

Click the DiSEqC item in the Auto Search Menu to open the USALS Setting Popup Menu.

Enter the user location latitude and longitude. Use numeric keys to enter values. Use

buttons to convert East and West.

Enter the latitude and longitude of the desired satellite. Use numeric keys to enter values.

Use buttons to convert East and West.

Click Store to save the input information. The antenna will direct itself towards the computed

USALS result.

If it is physically impossible to direct the satellite, an error will be displayed. Press the "Back"

key and enter new information if this happens.

Use the Signal Strength Bar to check if a satellite signal is received from the new antenna

direction.

Use Nudge East/West or Go to Reference to help the antenna work.

9.6 Auto Search Function

Auto Search is the one used most frequently used methods of channel search. It is intended to

have the receiver automatically search all the channels from the satellite you selected.

Select "Auto Search" and then press the OK button.

Select the satellite using the OK button. If you want to

change the Satellite Information, press the GREEN

button on the remote control.

Set the LNB information and DiSEqC information for

the satellite. You can use the existing setting. To

change the setting, use the buttons.

You can select the transponder (TP) you want to use

and check the difference in signal strength and

reception quality from one transponder to another.

Set DiSEqC port to OFF (or to a port you want to use,

if any)

Select the type of channels to search: FTA,

Scrambled, ALL or Network.

Start searching for TV and radio channels using the

above settings. Press the RED button.

TV and radio broadcast channels will be searched.

The names of the channels will be listed.

Press the EXIT button to return to viewing mode and

check whether the reception of the selected channel

is good.