Owner manual

General Installation

21” Centrer to Center Mounting Holes

Ensure Heater is Vertically Plumb

Fig. 1 : Mounting Bracket Hole Spacing

Fig. 2 : Mounting Bracket Assembly

 &%$%% I$ ($

1. Locate the general location of the water heater

placement.

2. Place the water heater mounting bracket against the

wall, vertically plumb the mounting bracket and use

a pencil to mark the location of the mounting holes.

See Fig. 1.

3. Remove the bracket from the wall and drill the

required diameter and depth hole for the wall

anchors, position in the center of each mark.

4. Mount the anchors flush or slightly recessed in the

drilled holes with threaded side of anchor inside the

wall.

5. Mount the bracket onto the water heater using the

rovided mounting bolts. Ensure the mounting bolts

are fully tightened and the bracket is securely fas-

tened to the water heater. See Fig. 2.

6. Reposition the bracket and water heater onto the

all and align the bracket and wall anchor holes.

Insert the two mounting bolts through the mounting

holes and loosely tighten.

7. Vertically plumb the water heater and tighten the

mounting bolts securely.