Install Instructions

4
Fig. 7 - Prestige Trimax - New Igniter
3. Tighten 2 igniter screws by hand, then torque
screws between 13 and 18 lbf-in.
Do not exceed the recommended max. torque
value for the igniter attachment screws to
prevent the igniter stems from distorting.
4. Place burner/burner plate/insulation assembly care-
fully in position. Do not secure the assembly just yet.
5. If removed previously, reinstall the blower and gas-
ket.
6. Secure burner plate using the retained nuts. Torque
at 50 lbf-in.
7. Reinstall the venturi/gas valve assembly on blower
using retained screws.
8. Reconnect the gas pipe to the gas valve connec-
tion.
1.5.6 Installation of Spark Generator
1. Install spark generator on bracket using 2 screws.
2. Locate the spark generator with bracket (A) on the
blower (B). (See Fig. 9), and secure using 2 of the
venturi-to-blower screws.
3. Connect the spark generator cable with connector
(C) to the new igniter.
NOTICE
PRESTIGE IGNITION KIT - INSTALLATION INSTRUCTIONS
Fig. 6 - PT 250 Orice location
Gasket
Orice
PT version NG LP
250 None Required 0.250” – 6.3mm
Table 2 - Orice Sizes
1.5.4 Removing the Burner and Insulation
1. Remove heat exchanger bracket located at the
back of the heat exchanger. Discard bracket.
2. Remove burner plate nuts securing the burner mount-
ing plate to the heat exchanger using a socket wrench.
3. Remove burner plate/burner and blower by release
4 screws securing the blower to the burner plate.
Retain for later reinstallation. Then remove blower
from burner plate.
4. Remove insulation from burner. Discard according to
applicable local regulations.
5. Disconnect the igniter wiring from the igniter. Discard.
6. Using the Torx wrench, release two screws and
remove the igniter and gasket from the burner
mounting plate. Discard all.
If the gasket is stuck on the igniter support, use
a flat head tool and release it carefully from the
surface. Be careful not to scratch the surface.
7. Clean combustion chamber. Refer to the installa-
tion manual of the appliance.
1.5.5 Installation of new Insulation and Burner
1. Slide the newly supplied burner insulation over the
existing burner tube.
2. Install the new igniter (See Fig. 7), with its new gas-
ket, on the burner mounting plate support, paying
attention not to damage the new insulation.
NOTICE