Install Instructions

PRESTIGE TriMax Control

and/or Display Module Replacement

13. Mount the new Trimax Display Module into the

enclosure using existing screws. Tighten all

(6) screws properly to secure the Display

Module.

14. Reconnect remaining Molex connectors in the

proper positions. Connectors are designed to fit

only into its respective mating connector.

Installation of Trimax Control Module

15. Mount the Trimax Control Module into the

enclosure by positioning the board onto the pro-

truding pins.

16. Use existing mounting screws to secure the

Control Module.

17. Reconnect the 8 Molex connectors to proper

positions as shown in Fig. 5. Each connector is

designed to fit only in its respective mating

connector.

18. Reconnect ignition cable onto the Control

Module ignition connector.

19. Place the rear cover in place and lock in the top

retaining tabs.

20. Tilt control panel assembly upward and lock

sliding tabs in place.

21. Remount the front jacket panel to the boiler.

22. Turn power to the unit “ON” and return the

boiler to service.

23. Return to page 2 and enter settings recorded in

Table 1 back into the Trimax control.

Prestige Excellence units require setting Prestige

Model to Excellence and DHW Demand Type to

Sensor.

If the Prestige is in a Cascade System, Cascade

Autodetection must be performed after replac-

ing a Control or Display Module.

NOTICE

Fig. 7. Display Module Mounting

Prestige_TriMax_Control_Display_Module_DCR639 1/14/14 9:45 AM Page 5