Manual

"-:516)<176;;-5*4A!=887:<
1
. If assembly needs to be extended to meet wall thick-
ness requirements the two pipes supplied in the kit may
be replaced using the same diameter, solid, single PVC
pipe.
%0-6 -@<-6,16/ <0- );;-5*4A 4-6/<0 D"
-@+--,<0-4-6/<07.818-;=8841-,16<0-31<*A57:-
<0)616+0-;D"=;-+7=8416/;<7-@<-6,<0-
4-6/<07.<0-<-:516)<176);;-5*4A)14=:-<7+75
84A+7=4, :-;=4< 16 ;->-:- 8-:;76)4162=:A ,-)<0 7:
;=*;<)6<1)48:78-:<A,)5)/-
2. Support the termination assembly at the wall pene-
tration as shown in Fig. 4.
- Use support bracing to support the termination
assembly and to prevent horizontal slippage or
vertical movement.
- Any clamps or bracing used to support the ter-
mination assembly must be such that it does not
penetrate the assembly piping or cause stress
and potential cracking of the assembly piping.
WARNING
Installing Vent Termination Kit
10
=4<184-6;<)44)<176!1,-?)44
1
. On installations of multiple PRESTIGE boilers,
install the concentric vent/air termination assemblies
as described in this manual.
2. The wall penetration of the termination assemblies
should be such that the vent outlet is a, minimum 12
inches between centerlines from the adjacent termi-
nation assembly of the other boiler for installations in
the U.S. as shown in Fig. 5. For installations in
Canada, provide clearances as required by CSA
B149.1 or 149.2.
"0-+75*=;<176)1:164-<7.<0- !"1;,-.16-,
);*-16/8):<7.),1:-+<>-6<;A;<-5<1;67<+76
;1,-:-, ); ) .7:+-, )1: 16<)3-  "0- :-9=1:-, +4-):
)6+-7.)6),2)+-6<*714-:>-6< <7 ).7:+-,)1:164-<
,7-; 67< )884A 16 ) 5=4<184- 16;<)44)<176 7.  !
"*714-:;
-.-:-6+-1/8)/-.7:<0-+76.1/=:)<176,15-6
;176;.7:<0->-6<)6,+75*=;<176)1:164-<<-:516)
<176;.7:-)+0=61<16;<)44-,16)5=4<184-16;<)44)<176
;;-5*416/"-:516)<17675876-6<;
NOTICE
NOTICE
=4<184-7:1B76<)46;<)44)<176
1/
"-:516)<1764-):)6+-;7.1:-+<$-6<
;A;<-5
1/