PVC/CPVC Sidewall Vent Termination Kit Instructions

PVC/CPVC Low Profile Sidewall
Vent Termination Kit
3
3. Use the wall plate as template to locate the
mounting holes on the outside wall.
- For masonry type walls drill a 3/16” hole
and insert the anchors supplied with the
vent.
- For wood type wall drill a 1/8” pilot hole at
each location.
4. Install the air intake piping and the vent piping
through the penetration holes. Ensure the air
intake piping extends beyond the exterior face
of the wall 1” and the vent piping extends 2 1/4”
beyond the exterior face of the wall.
5. Prior to cementing the wall plate to the vent and
air pipes. The installer should:
- Deburr the inside and outside of the pipe
ends.
- Chamfer the outside of the pipe ends to
allow even distribution of cement when
joining.
- Clean and dry the pipe ends and wall plate
fittings.
Prior to assembly/gluing wall plate the vent and
air piping, dry fit the wall plate to ensure it
mounts flush against exterior wall.
6. When assembling the wall plate to the vent and
air pipes the installer should:
a. Handle the wall plate and pipes carefully to
prevent contamination of surfaces.
b. Apply a liberal amount of primer to the end
of the pipes and the wall plate sockets.
c. Apply a light uniform coating of approved
cement to both surfaces. The end of the
pipes and the sockets of the wall plate,
while the primer is still wet.
d. With the cement still wet, the wall plate
should be mounted onto the pipe ends.
Ensure the pipe end is inserted fully into
the socket of the wall plate.
7. From the inside of the exterior wall apply a
bead of high temp silicone (RTV) around the
vent and air intake piping where it penetrates
through the wall.
8. Secure the wall plate to the exterior wall using
the mounting screws supplied with the vent.
9. Install the termination plate onto the wall plate
as shown in Figure 1 using the screws supplied
with the vent termination.
NOTICE
Pipe Size
Vent Pipe
Hole Size
Air Pipe
Hole Size
2” PVC/CPVC 4” 2 3/8”
3” PVC/CPVC 4” 3.5”
4” PVC/CPVC 5” 4.5”
Table 1