Install Instructions

PRESTIGE Wall Mounting
Bracket Kit Instructions
1
Kit Part Numbers: PSRKIT21
Parts List
(1) Wall Mounting Bracket
(2) Lag Screws 3/8” x 3” Hex Head (For Wood
Studs)
(2) Anchors (Double Expansion Shields) 5/16” x 1-
1/4” (For Solid Walls)
(2) Bolts 5/16-18 x 1-3/4” Hex Head (For Use With
Above Anchors)
(2) Washers 3/8”
Recommended tools:
- Drill
- Drill Bit 1/4”” (For Lag Screws)
- Drill Bit 5/8” (For Anchors)
- Open-end wrench
- Tape Measure
- Level
Indicates a potentially hazardous situation
which, if ignored, can result in serious
injury or substantial property damage.
Indicates special instructions on installa-
tion, operation or maintenance, which are
important to equipment but not related to
personal injury hazards.
NOTICEWARNING
Failure to follow instructions below can
result in severe personal injury or damage if
ignored.
• Instructions are for a qualified installer/
service technician.
• Read all instructions before proceeding.
• Follow instructions in proper order.
The PRESTIGE should be wall mounted
using the bracket provided with the boiler.
The PRESTIGE is not designed for floor
installation. If floor installation is required
an optional floor stand is available through
Triangle Tube.
The wall used for mounting the PRESTIGE
Solo must be vertically plumbed and capable
of supporting a minimum of 130 pounds (59
kg) for the PRESTIGE 60/110, 175 pounds
(80 kg) for the PRESTIGE Solo 175/250 and
250 pounds (115 kg) for the PRESTIGE 399
and PRESTIGE EXCELLENCE. Failure to
comply with these requirements could result
in personal injury, death or substantial prop-
erty damage.
WARNING WARNING
NOTICE