User Guide
Table Of Contents
- Table of Contents
- Product & Safety Information
- Homeowner
- Technician
- Service and Maintenance
- PRESTIGE Operation
- Boiler & System Water
- Section I - Combustion Air - Prevention of Contamination
- 1.1 Potential Contaminating Products
- Section II - Maintenance Schedule
- 2.1 Service Technician
- 2.1.1 General
- 2.1.2 Poor Performance or Combustion
- 2.2 Owner Maintenance
- 2.2.1 Periodic
- 2.2.2 Monthly
- 2.2.3 Every 6 Months
- Section III - Maintenance Procedures
- 3.1 Daily Maintenance
- 3.1.1 Check the Surrounding Area
- 3.1.2 Check Combustion Air Inlets
- 3.1.3 Check Temperature Display and Pressure Gauge
- 3.2 Monthly Maintenance
- 3.2.1 Check Vent Piping
- 3.2.2 Check Combustion Air Inlet Piping
- 3.2.3 Check Pressure Relief Valve
- 3.2.4 Check Condensate Drain System
- 3.2.5 Check Automatic Air Vents (If Used)
- 3.3 6-Month Maintenance
- 3.3.1 Check Water and Gas Piping
- 3.3.2 Operate Pressure Relief Valve
- Section IV - O
- Section V - ACVMax Operation
- 5.1 ACVMax Navigation
- 5.2 ACVMax Menu Structure
- 5.3 Home Screen
- 5.4 Status Line Messages
- 5.4 Main Menu
- 5.5 CH/DHW Operation Menu
- 5.6 Boiler Information
- 5.7 Information Items
- 5.8 Lockout History
- 5.9 Lockout Screen
- 5.10 Manual Reset Hard Lockouts
- 5.11 Automatic Reset Soft Lockouts
- Section VI - Replacement Parts
- Parts
- Solo 80/110 Jacket Components
- Solo 155/175/250 Jacket Components
- Solo 299/399 Jacket Components
- Solo 80/110 Internal Components
- Solo 155/175/250 Internal Components
- Solo 299/399 Internal Components
- olo 80/110 & Excellence Burner Components
- Solo 155/175/250 Burner Components
- Solo 299/399 Burner Components
- Control Module Enclosure
- Display Module Enclosure
- Table of Contents
17
5.0 ACVMax Operation
5.7 Information Items
Information Item Description
Boiler Status
Displays the current operating state of the Prestige. This is the same as
the status line on the home screen.
Heating Call
Displays if a central heating call is present.
DHW Call
Displays if a domestic hot water call is present.
Boiler Firing Rate
Displays the current firing rate of the Prestige.
Ionization Current
Displays the current flame ionization current from the ignitor.
Boiler Setpoint
Displays the current setpoint of the Prestige.
Supply Temp.
Displays the current supply temperature of the Prestige.
Return Temp.
Displays the current return temperature to the Prestige.
Boiler Flue Temp.
Displays the current flue temperature of the Prestige.
Outdoor Temp.
Displays the current outdoor temperature.
DHW Storage Temp.
Displays the current DHW storage temperature when Indirect Water
Heater Sensor PSRKIT22 is installed.
External Modulation Signal
Displays the current external modulation signal being received from an
external controller.
Pressure
Displays the current system pressure.
CH Ignitions
Displays the number of central heating ignitions since the unit was
installed. This counter increases in increments of twenty.
CH Runtime
Displays the number of hours the Prestige has run for a central heating
call since the unit was installed.
DHW Ignitions
Displays the number of domestic hot water ignitions since the unit was
installed. This counter increases in increments of twenty.
DHW Runtime
Displays the number of hours the Prestige has run for a domestic hot
water call since the unit was installed.
Mix Zone Temperature
Displays the temperature of the low temperature mixed circuit.