Install Instructions

4
PRESTIGE SOLO & EXCELLENCE IGNITION KIT - INSTALLATION INSTRUCTIONS
1.5. Kit installation
1.5.1 Required tools and material
• Wrench, Torx, 25
• Wrench, 10 mm
1.5.2 Installation of Igniter and Spark Generator
1. Install the new igniter, with its new gasket, on the
burner mounting plate support (See Fig. 4).
2. Tighten 2 igniter screws by hand, then torque
screws between 13 and 18 lbf-in.
Do not exceed the recommended max. torque
value for the igniter attachment screws to pre-
vent the igniter stems from distorting.
3. Connect the ignition wire to the spark generator (1). Slide
the protection sleeve (2) over the connector (See Fig. 5).
Fig. 4 - Prestige Solo & Excellence - New igniter Installation
4. Remove the blower clamp screw (A). Retain for rein-
stallation. (See Fig. 6).
Fig. 5 - Prestige Solo & Excellence - Ignition Wire Connection
1
2
5. Locate the spark generator with bracket (B) on the
blower clamp (A), aligning bracket hole with blow-
er clamp hole. (See Fig. 6).
6. Reinstall the blower clamp screw (A) to secure
the spark generator bracket to the blower clamp.
Torque screw between 62 and 71 lbf-in.
7. Install the igniter cable boot so that the cable is
smooth with no sharp bends and doesn’t curl on
itself. See Fig. 7 & Fig. 8.
8. Connect the spark generator connector (C) to the
new igniter.
A
B
C
Fig. 6 - Prestige Solo & Excellence - Spark Generator Installation
Fig. 7 - Prestige Solo 155 to 399 - Igniter Kit Installed
Fig. 8 - Prestige Solo & Excellence - Igniter Cable Installation
OK NO
1.5.3 Printed Circuit Board replacement
1. Disconnect violet wire (ionization current return)
(See Fig. 13) from circuit board ground connection.
Discard the wire.
2. Disconnect all wire terminals from the board.
3. Remove the circuit board and discard according to
applicable local regulations (See Fig. 9).
4. Install new circuit board, making sure it is secured in
the retaining clips (See Fig. 10).
NOTICE