Install Instructions

ManualsBrandsTriangle Tube ManualsBoiler PartsOff Board Spark Ignition Kit For PA 110

PRESTIGE SOLO & EXCELLENCE IGNITION KIT - INSTALLATION INSTRUCTIONS

1.3. Initial task

Write down all the appliance settings and the chosen

conﬁguration for reference before bringing any change

to the appliance. A reference table is provided on the

last page of this document.

1.4. Boiler preparation

1.4.1 Required Tools and Material

• Flathead and Phillips Screwdriver

• Torx 20 Wrench

1.4.2 Combustion Chamber Insulation

1. The Ignition kit is shipped with a new combustion

chamber 2in1 insulation/gasket. This may need to

be installed with the new ignition kit. Boilers with

serial number before those listed in the table below

need to be replaced.

Model Serial Number

PA80 PA132660

PA110 PA131779

PA155 PA13163

PA175 PA127120

PA250 PA137281

PA299 PA127280

PA399 PA128691

PA Excellence PA131819

2. If the Prestige serial number is after the listed num-

ber above, no change is required to the insulation/

gasket.

3. Refer to the installation manual for installation pro-

cedure.

1.4.3 Procedure

4. Turn the boiler oﬀ by pressing the power switch

5. Disconnect electrical power at the external electric box

• Avoid electrical shock by disconnecting the

electrical supply prior to performing any operation

on the internal parts of the boiler.

• Before any operation on the internal components

of the appliance, allow the appliance to cool

down to room temperature. Some components

can be very hot.

• Failure to comply will result in substantial property

damage, serious injury, or death.

DANGER

6. Shut oﬀ the gas supply to the boiler at the main manual

shut oﬀ valve.

7. Remove boiler front panel to access the electronic

board and the burner (See Fig. 2).

x 3

Fig. 2 - Prestige Solo & Excellence - Front Panel Removal

8. Disconnect the black ignition cable from the front

of the electronic box.

9. Open the front cover of the electronic box (See Fig. 3).

Discard the cover.

Fig. 3 - Prestige Solo & Excellence - Removal of Control Box

Front Cover

10. Disconnect the igniter wiring from the igniter. Discard.

11. Using the Torx wrench, release two screws and

remove the igniter and gasket from the burner

mounting plate. Discard all.

If the gasket is stuck on the igniter support, use

a flat head tool and release it carefully from the

surface. Be careful not to scratch the surface.

NOTICE