Install Instructions (Venting)

ManualsBrandsTRIANGLE TUBE ManualsBoilersPrestige Solo 110 95% AFUE Condensating Gas Boiler with 86000-99000 BTU and 110000 Input Modulating

1.0 Pre-Installation Requirements

.2 Vent/Combustion Air Piping and

Materials

The installation must conform to the requirements of

the authority having jurisdiction or, in the absence of

such requirements, to the National Fuel Gas Code,

ANSI Z223.1/ NFPA 54, and/or Natural Gas and

Propane Installation Code, CAN/CSA B149.1.

The Prestige is certified per ANSI Z21.13 as a Category

IV (indoor air) or Direct Vent (sealed combustion) appli-

ance. A Category IV appliance utilizes uncontaminated

indoor or outdoor air (surrounding the appliance) for

combustion. A Direct Vent appliance utilizes uncontami-

nated outdoor air (piped directly to the appliance) for

combustion.

To reduce the potential risks associated with indoor

contaminates (listed on page 12), flammable vapors

and tight housing construction (little or no infiltra-

tion air), it is recommended to pipe uncontaminated

combustion air directly from the outdoors to the

appliance. This practice also promotes higher sys-

tem efficiency by reducing heated indoor air from

being exhausted from the building and replaced by

cold infiltration air.

The Prestige requires a Category IV venting system which

is designed for pressurized venting and condensate.

The vent and combustion air materials (piping, fit-

tings and cement) must meet the listed require-

ments in this manual. Failure to comply with these

material requirements could result in severe per-

sonal injury, death or substantial property damage.

NOTICE

BEST PRACTICE

WARNING

1.2.1 PVC and CPVC Vent and Combustion Air

Piping and Fittings

VC Schedule 40 - ANSI/ASTM D1785

PVC-DWV - ANSI/ASTM D2665

CPVC Schedule 40 - ANSI/ASTM F441

1.2.2 PVC and CPVC Pipe Cement and Primer

PVC - ANSI/ASTM D2564

CPVC - ANSI/ASTM F493

For installations in Canada, all piping, fittings and

cement/primer material must be certified and listed

to ULC-S636. Ipex Inc. is an approved manufacturer

of ULC S636 vent components.

Use of cellular core PVC (ASTM F891) cellular core

CPVC, or Radel® (polyphenolsulfone) in venting

systems is prohibited. Cellular core pipe may be

used for combustion air piping.

DO NOT mix a PVC/CPVC vent system & components

with other vent system materials & components. Seal

all PVC and CPVC pipe and fittings with the appropri-

ate primer and cement. Failure to comply with this

requirement could cause the venting system to fail

resulting in leakage of flue products into the living

space.

NOTICE

WARNING