Installation Instructions

2
Important!
The Blue cable must be connected to the 12V switched to enable the Car Kit to go into standby mode.
Do not connect the Blue cable to the +12V permanent. Doing so may discharge the battery of the
vehicle and prevent the Car Kit from being reset.
C. Connecting Accessories
The following illustration shows where to connect accessory devices.
Control module
Speaker
Microphone
Junction box
Control module The control module should be located within reach and view of the
driver.
Speaker For best reception, the speaker should be mounted at least 80 cm (30
inches) from the Car Kit’s microphone.
Microphone Ideally, the microphone should be located in front of the user and
above waist height.
D. Installing the microphone
Before installing the microphone, take note of the following:
• Make sure that the cable can reach from the microphone to the speaker. If the cable is
too short, relocate the microphone. Do not lengthen the cable.
• The supplied microphone is uni-directional. For best results, place the microphone in
front of the person talking. It has a reception angle of 60 degrees, and is most effective
within a 60 cm radius.
Using the microphone stand
Find a suitable place for the microphone stand. Remove dust and grease from the surface.
1. Remove the protective cover from one
side of the double-sided tape and
press it firmly onto the bottom of the
stand.