Transmitter Antenna Indicator light Intensity knob (1-10) Upper button (sound) Middle button (left jack) Lower button (right jack) Lanyard placement Installing Nylatch® fasteners on receiver mounting plate.
The Pro Control® G3 Please read these instructions before using your Pro Control® G3 The Pro Control® G3 controls a variety of remotely operated dog training equipment, including: • Several brands of bird releasers used for training pointing and flushing dogs • Most brands of launchers used for retriever training • Several accessory items for retriever launchers such as “retiring guns” and sound-making devices The Pro Control® G3 is completely compatible with the Pro Control RL.
Accessories for the Pro Control® G3: Order these accessories from your Tri-Tronics dealer, on our web site, or by calling us at 1-800-456-4343: • Extension cord for receiver • Transmitter holster Please note you may order a separate receiver or transmitter for your Pro Control® G3 system at any time.
1. Turn the receiver on. 2. Set the transmitter dial to the number you want to use to operate that receiver (1-10). 3. Press the SET switch – the red on/off light will glow for about five seconds. 4. Press any of the three transmitter buttons during the 5-second period. The receiver light will blink once to confirm that your setting took effect. 5. If you want to verify that your setting took effect, muffle the speaker with your hand and press the sound button on the transmitter.
Attaching the Receiver to Your Training Equipment. Attach the Pro Control® G3 receiver to your training equipment in accordance with your manufacturer's directions. (If you use our Nylatch® fasteners, see illustration for installing these in your receiver.) Be careful not to attach the receiver to a training device in such a way that either the receiver or its antenna will be in the path of whatever is launched.
H. If you are a very long way from the training device, range could be the problem. (You can use the sound button to confirm that the receiver is getting your transmitter signal.) Maximize your range by holding the transmitter straight overhead when you press the button. You can also improve range by raising the receiver higher off the ground, and by pointing its antenna straight up or straight down. Never operate a Pro Control® G3 receiver without an antenna. I.