User Manual

T R I - T R O N I C S
Battery Charging
Reinstall the protection caps on the collar and transmitter
jacks to keep dirt, debris, and water out of the charging jacks.
Be sure you seat the collar jack cover down firmly so that
it is level with the surface of the collar, as shown in the
illustration. Keeping the charging jacks clean and dry ensures
that your chargers make good contact. If the collar charging
jack becomes dirty, clean it as described in the section, “Care
and Cleaning” (page 24). If either jack protection cap becomes
lost or damaged call our Customer Service Department for
a replacement.
Use only the correct Tri-Tronics chargers to charge your
Remote Trainer. Using the wrong type of charger may damage
batteries or the unit itself. Do not charge batteries that are not
installed in a Remote Trainer.
Charging Time
Charge your Remote Trainer for at least 14 hours. It's okay
to use your Remote Trainer before the 14 hours are up; it
will function normally. A 14 hour charge ensures full
battery capacity.
Page 22 Remote Trainer
Protection cap
fitted properly
Protection cap not fitted
properly. Moisture and debris
can enter charging jack.