User guide

Receiver Light
(“Fuel Gauge”)
Flashes twice per second every four
seconds when the collar is turned on.
This light will be:
Green when the batteries are full.
Amber when the batteries are partly discharged.
Red when the batteries need charging very soon.
Rapid red flashing means the batteries are completely dead and
the unit will not function. Note that it takes 20 seconds after collar
turn-on for the light to register battery level.
Collar Strap Retaining Loops
(“Belt Loops”)
Insert the collar strap through all three belt loops and snug
the strap against case.
Multi Sport
®
-2 G2 and Multi Sport
®
-3 G2: Install the colored strap
that matches the colored dot on each receiver.
See the section “Fitting the Collar on the Dog”
for more information.
Battery Pack Access Screws
Remove these two screws to remove the battery pack. Position the
new pack in place and replace the screws. (Note: The battery pack
does not need to be removed for charging.)
Very important: Do not remove or tamper with the receiver serial
number label that is visible when the battery pack is removed.
Doing so will void your warranty. This label is a seal that maintains
waterproof integrity of the receiver.
The G2 receiver is waterproof.